安装PROE_V4_M180_W64时遇到的问题

mfy1969mx · 发表于 2012-2-20 18:03

我在安装PROE_V4_M180_W64时，按照下边说明进行操作，遇到“汉字”标注的问题：
.boot up your pc with windows
.start pro/e setup
.open ptc_licfile.dat with your fav txt-editor
.replace every occurance of 00-00-00-00-00-00 with the one shown in the bottom left corner of the Pro/e setup
(its your mac-id, format: xx-xx-xx-xx-xx)
.install pro/e - pro/m - pro/ds, i dont care which one or in which order
.on license-config screen select "nodelocked license" and point to edited ptc_licfile.dat
.blalala install

next for pro/engineer:
(if u didnt install the complete package, u get "missing file" errors, accept or bleed)
.run ptc.pro engineer.wildfire.4.0-patch.exe, point to <installdir>\x86e_win64\obj folder
.edit <pro/e installdir>\bin\proev.bat(此文件找不到，下边的编辑就不能进行）
change "%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr%" in
"%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr% PTC_KEY=0"
(add PTC_KEY=0)

pro/mechanica:
.run ptc.pro mechanica.wildfire.4.0-patch.exe
.point to <pro/m installdir>\x86e_win64\bin
<pro/m installdir>\x86e_win64\obj(此文件夹找不到！参考其他文件，应该不需要此项。是否这样?）
<pro/m installdir>\x86e_win64\ptc
(in this order, after every "missing file" error)

pro/distributed services:
.run ptc.distributed.services.4.0-patch.exe and point to <pro/ds installdir>\x86e_win64\obj