Pro/Engineer wildfire 5.0 M100 安装后，无法启动

elsonbeckham · 发表于 2011-9-25 17:06

我的Pro/Engineer wildfire 5.0 M100安装后无法启动提示:
Unable to launch Pro/ENGINEER because no valid configuration (*.psf) files were found.Please run "ptcsetup" from your installation "bin" directory and create a PTC Startup File.This is needed for Pro/ENGINER to launchsuccessfully.

为什么会这样？？

请帮帮忙，谢谢。。。

elsonbeckham · 发表于 2011-9-25 17:21

Unable to launch Pro/ENGINEER because no valid configuration (*.psf) files were found.Please run "ptcsetup" from your installation "bin" directory and create a PTC Startup File.This is needed for Pro/ENGINER to launchsuccessfully.

错误：无法启动Pro/ENGINEER,因为未找到任何有效的配置（*psf)文件。请运行安装程序“bin"目录下的“ptcsetup"创建ptc启动文件。这是成功启动pro/ENGINEER所必需的操作。