proe安装出错后没有正常安装补丁却可以用

沪沽摩梭

proe4.0m040安装后出现这种错误，请指教！
我直接用的注册机生成license文件，就直接装了，后来发现还有补丁，然后就按照补丁说明
boot up your pc with windows
.start pro/e setup
.open ptc_licfile.dat with your fav txt-editor
.replace every occurance of 00-00-00-00-00-00 with the one shown in the bottom left corner of the Pro/e setup
(its your mac-id, format: xx-xx-xx-xx-xx)
.install pro/e - pro/m - pro/ds, i dont care which one or in which order
.on license-config screen select "nodelocked license" and point to edited ptc_licfile.dat
.blalala install

next for pro/engineer:
(if u didnt install the complete package, u get "missing file" errors, accept or bleed)
.run ptc.pro engineer.wildfire.5.0-patch.exe, point to <installdir>\i486_nt\obj folder
.edit <pro/e installdir>\bin\proev.bat
  change "%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr%" in
第一步没有做，直接做第二部，但是拷贝到OBJ后，PROVE.bat文件没有，后面都没有进行，然后运行PROE就可以了，请问我需要重新安装吗？

[ 本帖最后由 沪沽摩梭 于 2010-9-11 16:23 编辑 ]

野火

运行常见错误 License request failed for feature PROE_DDiTy: -8 或 :-9  解决方法
http://www.proewildfire.cn/thread-199-1-1.html