总提示我的工程图模板文件出错.

auovsceo

重点是FRM文件是保存的图框文件  文件内容又不像CONFIG那样可以用记事本打开随便编辑的.
搞不懂
以下是datafile_errors.txt的内容

ERROR - D:\ptc\formats\ls-part.frm, line 1 :
Keyword '#UGC:2' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 2 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 3 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 4 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 5 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 6 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 7 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 8 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 9 :
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 10:
Keyword '#-' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 11:
No space between values.
ERROR - D:\ptc\formats\ls-part.frm, line 12:
Keyword '#Creo' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 13:
Keyword '#UGC_TOC' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 14:
Keyword 'ND:0:Model_L05_PX:1' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 15:
Keyword 'ND:0DMTrail_L03:1' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 16:
Keyword 'DrawingPersistTable' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 17:
Keyword 'DrawingPrimdata' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 18:
Keyword 'Dwg_Drawing' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 19:
Keyword 'PglFontData#H#1' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 20:
Keyword 'PglFontData#1' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 21:
Keyword 'NEXT_TOC_ENTRY' is not valid.
ERROR - D:\ptc\formats\ls-part.frm, line 22:
No space between values.
ERROR - D:\ptc\formats\ls-part.frm, line 23:
No space between values.

生为于

模板没配置好，模板配置的路径是不是选错了

auovsceo

路径是手动选的 应该不会...一直没搞懂