能不能帮忙看一下这个关系式哪里出错了

一问三不知

mass=pro_mp_mass
MASS=MP_MASS("")

cmat=ptc_material_name+" "+"T="+adtos(smt_thickness)

error发现无效的符号 'adtos'。

if SMT_THICKNESS==ceil(SMT_THICKNESS)
cmat=ptc_material_name+" "+"T="+itos(smt_thickness)+".0"
endif

if SMT_THICKNESS==0.001
cmat=ptc_material_name+""
endif
/* The following relations make the bend allowance parameters     */
/* of part to be dependent on the assigned material, if the value  */
/* of the parameter SMT_UPDATE_BEND_ALLOW_INFO is YES.  */
/* If you remove or change these relations, the check box         */
/* 'Use assigned material to define the value of the bend         */
/*  allowance parameters' in the Bend Allowance category          */
/* in sheet metal Preferences dialog box might stop working.      */
if ( SMT_UPDATE_BEND_ALLOW_INFO == YES && exists("PTC_MATERIAL_NAME") )
  if ( PTC_MATERIAL_NAME != "UNASSIGNED" )
    if ( string_length( material_param("BEND_TABLE") ) > 0 )
      SMT_PART_BEND_TABLE_NAME = material_param("BEND_TABLE")
    endif
    if ( material_param("INITIAL_BEND_Y_FACTOR") > 0.0 )
      SMT_PART_BEND_ALLOW_FACTOR_TYPE = "Y FACTOR"
      SMT_PART_BEND_ALLOWANCE_FACTOR = material_param("INITIAL_BEND_Y_FACTOR")
    endif
  endif
endif
SMT_DFLT_BEND_RADIUS = SMT_THICKNESS
SMT_DFLT_CRNR_REL_WIDTH = SMT_THICKNESS
SMT_DFLT_CRNR_REL_DEPTH = SMT_THICKNESS
SMT_DFLT_BEND_REL_WIDTH = SMT_THICKNESS
SMT_DFLT_BEND_REL_DEPTH = SMT_THICKNESS * 2.0
SMT_GAP = SMT_THICKNESS * 0.5
SMT_DFLT_EDGE_TREA_WIDTH = -SMT_GAP
SMT_DFLT_MITER_CUT_WIDTH = SMT_GAP
SMT_DFLT_MITER_CUT_OFFSET = SMT_THICKNESS * 1.1
SMT_DFLT_BEND_REL_LENGTH = SMT_THICKNESS * 4.0

一问三不知

只是想把钣金的宽度显示出来，不想手输

liurunxing

将adtos换成itos试试。

一问三不知

liurunxing 发表于 2020-5-25 13:23
将adtos换成itos试试。

换过了，没用，这个应该是四舍五入，没用办法真正的显示钣金厚度

机械孙

好复杂的样子！